![]() ![]() If no button is pressed within 12 seconds, nothing will be changed. A long press of the Settings button (more than 2 seconds) will cause the newest device to be overwritten. A short press of the Settings button (less than 2 seconds) will cause the oldest device in the doorbell memory to be overwritten. There is a 12 second window to complete this operation.įor doorbells with no Halo Light: The Red LED will flash rapidly. A long press of the Settings button will cause the device indicated by the Halo colour to be overwritten with the new device. Repeated short presses will cycle through the colours for all linked devices. A second short press will cause the Halo colour of the 2nd device to be displayed. A short press of the Settings button will cause the doorbell to indicate the Halo colour of the 1st stored device in the memory. You now have the option to remove one of the devices already linked to the doorbell, and replace it with the new device. Please refer to this table: Series 3 (DC311xx and DCR311xx)Ģ wired push buttons and 5 wireless devicesįor doorbells with a Halo Light: After attempting to add the new device, wait for the doorbell to beep twice. Your doorbell will accept 2, 4, 5 or 6 devices according to the model. You have exceeded the maximum number of wireless devices that your Honeywell Home doorbell can connect to. The doorbell will play an alert sound, and your motion sensor is now linked. The doorbell will play an alert sound, and your motion sensor is now linked.įor internal motion sensor (HS3PIR1x, HS3PIR2x): Open the battery compartment, or detach the motion sensor from its base to operate the tamper switch. ![]() Move across the detection area to trigger the motion sensor.If however the motion sensor is set to DAY operation adjust the DUSK control fully anti-clockwise to its minimum setting. If the motion sensor is set to NIGHT operation for use with lighting adjust the DUSK control fully clockwise to its maximum setting.Set the TIME control fully anti-clockwise to its minimum setting.Press and hold the settings button on the doorbell until an amber light flashes, either from the small LED indicator on the side of the doorbell, or from the Halo Light (Depending on product type).įor external motion sensor (L430x): configure the motion sensor for Walk Test according to the selected Day or Night operating mode as follows: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |